Unit 1: Basic Circuit Analysis and Simplification Techniques MCQ's

Updated on 2017/09/23 16:07

1.Kirchhoff s current law states that
(a) net current flow at the junction is positive
(b) Algebric sum of the currents meeting at the junction is zero
(c) no curreht can leave the junction without some current entering it.
(d) total sum of currents meeting at the junction is zero

2.Kirchhoffs current law is applicable to only
(a) junction in a network
(b) closed loops in a network
(c) electric circuits
(d) electronic circuits

3.Kirchhoff’s voltage law is related to
(a) junction currents
(b) battery e.m.fs.
(c) IR drops
(d) both (b) and (c)
(e) none of the above

4.Superposition theorem can be applied only to circuits having
(a) resistive elements
(b) passive elements
(c) non-linear elements
(d) linear bilateral elements

5.The concept on which Superposition theorem is based is
(a) reciprocity
(b) duality
(c) non-linearity
(d) linearity

6. Thevenin resistance Rth is found
(a) by removing voltage sources along with their internal resistances
(b) by short-circuiting the given two terminals
(c) between any two 'open' terminals
(d) between same open terminals as for Etk

7. An ideal voltage source should have
(a) large value of e.m.f.
(b) small value of e.m.f.
(c) zero source resistance
(d) infinite source resistance

8. For a voltage source
(a) terminal voltage is always lower than source e.m.f.
(b) terminal voltage cannot be higher than source e.m.f.
(c) the source e.m.f. and terminal voltage are equal

9.To determine the polarity of the voltage drop across a resistor, it is necessary to know
(a) value of current through the resistor
(b) direction of current through the resistor
(c) value of resistor
(d) e.m.fs. in the circuit

10."Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen from the terminals of the load". The above statement is associated with
(a) Millman's theorem
(b) Thevenin's theorem
(c) Superposition theorem
(d) Maximum power transfer theorem

11."Any number of current sources in parallel may be replaced by a single current source whose current is the algebraic sum of individual source currents and source resistance is the parallel combination of individual
source resistances".
The above statement is associated with

(a) Thevenin's theorem
(b) Millman's theorem
(c) Maximum power transfer theorem
(d) None of the above

12."In any linear bilateral network, if a source of e.m.f. E in any branch produces a current I in any other
branch, then same e.m.f. acting in the second branch would produce the same current / in the first branch".
The above statement is associated with

(a) compensation theorem
(b) superposition theorem
(c) reciprocity theorem
(d) none of the above

13. Which of the following is non-linear circuit parameter ?
(a) Inductance
(b) Condenser
(c) Wire wound resistor
(d) Transistor

14. A capacitor is generally a
(a) bilateral and active component
(b) active, passive, linear and nonlinear component
(c) linear and bilateral component
(d) non-linear and active component

15."In any network containing more than one sources of e.m.f. the current in any branch is the algebraic sum of a number of individual fictitious currents (the number being equal to the number of sources of e.m.f.), each of which is due to separate action of each source of e.m.f., taken in order, when the remaining sources of e.m.f. are
replaced by conductors, the resistances of which are equal to the internal resistances of the respective sources".
The above statement is associated with

(a) Thevenin's theorem
(b) Norton's theorem
(c) Superposition theorem
(d) None of the above

16. Kirchhoff s law is applicable to
(a) passive networks only
(b) a.c. circuits only
(c) d.c. circuits only
(d) both a.c. as well d.c. circuits

17.Kirchhoff s law is not applicable to circuits with
(a) lumped parameters
(b) passive elements
(c) distributed parameters
(d) non-linear resistances

Show Answer
18.Kirchhoff s voltage law applies to circuits with
(a) nonlinear elements only
(b) linear elements only
(c) linear, non-linear, active and passive elements
(d) linear, non-linear, active, passive, time varying as wells as time-in-variant elements
Show Answer
19.The resistance LM will be
(a) 6.66 Q
(b) 12 Q
(c) 18Q
(d) 20Q
Show Answer

20. For high efficiency of transfer of power, internal resistance of the source should be
(a) equal to the load resistance
(b) less than the load resistance
(c) more than the load resistance
(d) none of the above

Show Answer

21. Efficiency of power transfer when maximum transfer of power   cxurs is
(a) 100%
(b) 80%
(c) 75%
(d) 50%

Show Answer

22. If resistance across LM in Fig. 2.30 is 15 ohms, the value of R is
(a) 10 Q
(6) 20 Q
(c) 30 Q
(d) 40 Q
Show Answer

23. For maximum transfer of power, internal resistance of the source should be
(a) equal to load resistance
(b) less than the load resistance
(c) greater than the load resistance
(d) none of the above

Show Answer

24. If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
(a) a voltage source
(b) a current source
(c) both of above
(d) none of the above
Show Answer

25.The circuit whose properties are same in either direction is known as
(a) unilateral circuit
(b) bilateral circuit
(c) irreversible circuit
(d) reversible circuit
Show Answer

26.In a series parallel circuit, any two resistances in the same current path must be in
(a) series with each other
(b) parallel with each other
(c) series with the voltage source.'
(d) parallel with the voltage source
Show Answer

27.The circuit has resistors, capacitors and semi-conductor diodes. The circuit will be known as
(a) non-linear circuit
(b) linear circuit
(c) bilateral circuit
(d) none of the above
Show Answer

28. A non-linear network does not satisfy
(a) superposition condition
(b) homogeneity condition
(c) both homogeneity as well as superposition condition
(d) homogeneity, superposition and associative condition
Show Answer

29. An ideal voltage source has
(a) zero internal resistance
(b) open circuit voltage equal to the voltage on full load
(c) terminal voltage in proportion to current
(d) terminal voltage in proportion to load
Show Answer

30.A network which contains one or more than one source of e.m.f. is known as
(a) linear network
(b) non-linear network
(c) passive network
(d) active network
Show Answer
31. The superposition theorem is applicable to
(a) linear, non-linear and time variant responses
(b) linear and non-linear resistors only
(c) linear responses only
(d) none of the above
Show Answer

32.Millman's theorem yields
(a) equivalent resistance
(6) equivalent impedance
(c) equivalent voltage source
(d) equivalent voltage or current source
Show Answer

33. The superposition theorem is applicable to
(a) voltage only
(b) current "only
(c) both current and voltage
(d) current voltage and power
Show Answer

 

34.Between the branch voltages of a loop the Kirchhoff s voltage law imposes
(a) non-linear constraints
(b) linear constraints
(c) no constraints
(d) none of the above
Show Answer

35.A passive network is one which contains
(a) only variable resistances
(b) only some sources of e.m.f. in it
(c) only two sources of e.m.f. in it
(d) no source of e.m.f. in it
Show Answer

36. A terminal where three on more branches meet is known as
(a) node
(b) terminus
(c) combination
(d) anode
Show Answer

37. Which of the following is the passive element ?
(a) Capacitance
(b) Ideal current source
(c) Ideal voltage source
(d) All of the above
Show Answer

38.Which of the following is a bilateral element ?
(a) Constant current source
(b) Constant voltage source
(c) Capacitance
(d) None of the above
Show Answer

39.A closed path made by several branches of the network is known as
(a) branch
(b) loop
(c) circuit
(d) junction
Show Answer
40.A linear resistor having 0 < R < °o is a
(a) current controlled resistor
(6) voltage controlled resistor
(c) both current controlled and voltage controlled resistor
(d) none of the above
Show Answer

41. A star circuit has element of resistance R/2. The equivalent delta elements will be
(a) R/6
(b) fi
(c) 2R
(d) 4R
Show Answer

42.A delta circuit has each element of value R/2. The equivalent elements of star circuit with be
(a) RIG
(b) R/3
(c) 2R
(d) 3R
Show Answer
43. While calculating Rth in Thevenin's theorem and Norton equivalent
(a) all independent sources are made dead
(b) only current sources are made dead
(c) only voltage sources are made dead
(d) all voltage and current sources are made dead
Show Answer

44.The number of independent equations to solve a network is equal to
(a) the number of chords
(b) the number of branches
(c) sum of the number of branches and chords
(d) sum of number of branches, chords and nodes
Show Answer

45.The superposition theorem requires as many circuits to be solved as there are
(a) sources, nodes and meshes
(b) sources and nodes
(c) sources
(d) nodes
Show Answer

46.Choose the incorrect statement.
(a) A branch formed by the parallel connection of any resistor R and open circuit has the characteristic of an open circuit.
(b) A branch formed by the parallel connection of any resistor R and a short circuit has the characteristic of a short circuit.
(c) A branch formed by the series connection of any resistor R and an open circuit has the characteristic of an open circuit.
(d) A branch formed by the series connection of any resistor R and a short circuit has the characteristic of resistor R.
Show Answer

image.png

Find the node voltage VA.
A. 6V
B. 12
C. 4.25
D.3V

What is the current through R2?
image.png

A.  3.19 A
B . 319 mA
C.  1.73 A
D.  173mA

 

 

 

 

 

 


 

 

  

 

 

 

 

 

Table of Contents

 

References

  • WikiNote Foundation
Tags:
Created by Dhanshree Ghogare on 2017/09/20 11:22
Translated into en by Sujit Wagh on 2017/09/20 11:25